Table of Contents
Advertisement
F
o
r
t
r
e
s
s
9
1
0
0
F
o
r
t
r
e
s
s
9
1
0
0
device (most devices do not require this). Enabling this item reduces the load on the system power
supply by allowing the SCSI controller to power up SCSI devices one at a time upon booting.
Otherwise, all the devices power up at the same time. Most devices require you to set a jumper
before they can respond to this command.
When set to Yes, the Start Unit Command is sent to the SCSI device at system boot. When set to
No, each SCSI device powers up in the normal procedure.
The Send Start Unit Command setting is valid only if the
host adapter BIOS is enabled.
If this option is enabled for more than one SCSI device, the Start Unit Command is sent first to the
device with the lowest SCSI ID. When this device responds to the SCSI controller, the Start Unit
Command is sent to the next highest SCSI ID with a setting of Yes. The process continues until all
supported devices respond to the SCSI controller.
If many drives are set to Yes for Send Start Unit Command, the boot time varies depending on how
long it takes each drive to spin up.
O
n
O
n
143
l
i
n
e
M
a
n
u
a
l
l
i
n
e
M
a
n
u
a
l
A
Open
Advertisement
Table of Contents
