AOpen MX4SGI-4DN Online Manual page 39

Hide thumbs Also See for MX4SGI-4DN:
Table of Contents

Advertisement

M
X
4
S
G
I
-
4
D
N
/
M
X
4
S
G
I
-
4
D
N
/
If you intend to change the default setting, s
disks fully installed, Auto mode will not function properly, it's just b
all hard disks.
3.
Combined Mode: If you install traditional IDE hard disks and Serial A
Combined Mode. Under this mode, you may randomly choose eith
But please aware that Serial ATA will exist with IDE in a mapping
you with one IDE Channel only.
4.
Enhanced Mode: If you use the latest operating system (say, Win
set Enhanced Mode. The system is able to detect all six devices (traditi
mode. But please note that it is defaulted with using traditional IDE
Note: From our practical lab tests, we found no obvious problem or mistakes happened under Windows2000 operating system, but,
however, it doesn't confirm to the regulation recommended by Intel.
5.
SATA Only: You may select this SATA Only mode if you install Serial ATA hard disks only. It allows you to select booting sequence
from Port0 (SerialATA1) or Port1 (SerialATA2).
M
X
4
S
G
I
-
4
D
L
M
X
4
S
G
I
-
4
D
L
imply press Enter for a list of selection:
1.
Disabled: You
disks are installed on your system. Disabling this item may also cancel the detection
to Serial ATA hard disk during POST, which theoretically, could speed up your
boot-up timing a
intend to use Serial ATA hard disk later.
2.
Auto: This is the factory default setting of your motherboard. Basically, if your
system works properly, it's not necessary to change it. The system will automatically
recognize the first hard disk on ID
Note: Please be
may choose this item if you're sure that only traditional IDE hard
bit; however, please remember to re-adjust the settings here if you
E1 as the first boot device.
informed that when you are using Windows98/ME with six hard
ecause Windows98/Me cannot recognize Enhanced Mode to detect
TA hard disks at the same time, then you can choose this
er IDE hard disks or Serial ATA had disk as your first boot device.
way, which means it will occupy one of the IDE Channel and leave
dowsXP, Windows.NET Server), it is highly recommended that you
onal IDE x4, Serial ATA x 2) and functions perfectly under this
as the first boot device.
39
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mx4sgi-4dl

Table of Contents