I!-Pclink/Powerpoint Quickstart - AMX i!-PCLink/PowerPoint Instruction Manual

Introduction
4. In the Select!-PCLink/PowerPoint Install Location dialog, use the Browse button to navigate to
a directory other than the default install directory, if desired. Click Next. PowerPoint (for
Windows®) is not included in the setup, and must be obtained from Microsoft® or authorized
reseller.
5. In the i!-PCLink/PowerPoint Shortcut Creation dialog, select whether to install shortcut icons
for the installed components on your desktop.
6. Click Next in the Start i!-PCLink/PowerPoint Installation dialog to install the selected
components.
7. If needed, the installation program will prompt you to restart your system to complete the
installation.

i!-PCLink/PowerPoint Quickstart

By default, the installed files are located in :
C:\Program Files\AMX Control Disc\Solutions\i!-PCLinkPowerPoint.
1. In NetLinx Studio, open the file i!-PCLinkPowerPointTest2.axs, compile and download it into
a NetLinx master.
2. In NetLinx Studio, or TPDesign download the file i!-PCLinkPowerPoint2.tpd to an
AXT-CA10 or similar 10.4" touch panel set to device 128.
3. Launch i!-PCLinkPowerPoint.exe.
4. Next, you will need to configure the NetLinx connection settings. Press the Configure button
on the main page. (Note: for detail on connection settings, please see Configure
i!-PCLink/PowerPoint)
5. After settings all the appropriate connection settings, you can press the Connect button to
establish a connection between i!-PCLink/PowerPoint and NetLinx.
6. The NetLinx Connection Status indicator should blink upon successful connection.
FIG. 1 NetLinx Connection Status Indicator
2 i!-PCLinkPowerPoint