Photometric Chart; Battery Status - American DJ Mega Go Flood Par User Instructions

Mega Go Flood Par

Photometric Chart

Mega Go Flood Par Battery Status & Charging

Battery Status:

This function is used to check the life status of the battery.
Plug the fixture in and press the MODE button until "bXXX" is
displayed. "XXX" represents an number between "000" and
"100". The number that is displayed is the remaining battery
life. If "b---" is displayed, it means the battery is dead or you are
running the unit on AC power. Please do not let the battery
fully die, this severly shortens the life of the battery.
Example: If "b050" is displayed, the battery is at half life. If
"b025" is displayed, the battery is at 25% life.
NOTE: When the battery is charging or if the battery life is
below 30% the digital display will flicker.
Battery Recharge: To recharge the battery, plug the supplied AC
cord into the AC input on the side of the unit and plug the other
end into a matching power supply. It takes about 6.5 hours to
reach full charge. The display will STOP flashing when the unit
reaches 100% charge.
Note: When unplugging the unit from charging and then
applying power via battery, there will be a minimal charge
drop.
For a faster recharge, put the Load Switch in the "Off" position
and the Battery Switch in the "ON" position.
ADJ Products, LLC - www.adj.com - Mega Go Flood Par User Manual Page 21 ADJ Products, LLC - www.adj.com - Mega Go Flood Par User Manual Page 22