Onkyo TX-NR1008 Firmware Update page 3

■Update procedure
1
Press RECEIVER followed by SETUP on the
remote controller.
Main menu will be displayed on TV screen.
Procedures thereafter can also be performed on
the AV receiver by using its SETUP, arrow,
and ENTER buttons.
2
Go to "Hardware Setup" menu.
3
Go to "Firmware Update" menu.
Note that the Firmware Update option will be
grayed out about 50 seconds after the AV
receiver is turned on. Please wait.
4
Select "via NET" and press ENTER.
5
Select "Update" and press ENTER.
Updating will begin.
As the updating progresses, the TV screen may
disappear depending on the program updated.
In this case, you can see the update progress on
the front display of the AV receiver. The TV
screen will reappear when you finish the update
and turn on the AV receiver.
6
Message "Complete!" appears on the front
display of the AV receiver, indicating that the
update has been completed.
7
Using ON/STANDBY on the front panel,
turn off and on the AV receiver.
Do not use ON or STANDBY on the remote
controller.
Congratulations!! Now you have the latest
firmware on the AV receiver.
(Go to the next page for troubleshooting.)
En
3