Advertisement
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow
them could damage the product or cause a hazardous
condition.
2. Check the ratings given in the instructions and on the
product to make sure the product is suitable for your
application.
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out product
operation as provided in these instructions.
CAUTION
Electrical Shock or Equipment Damage Hazard.
Can shock individuals or short equipment
circuitry.
Disconnect power supply before installation.
Location
Select a location on an inside wall away from:
• drafts or dead air spots behind doors and corners.
• hot or cold air ducts.
• radiant heat from the sun or electrical equipment.
• unheated areas behind the thermostat wall.
Locate the T7147 about 5 ft (1.5 m) above the floor in an
area with good air circulation within easy reach of users.
T7147 REMOTE SENSOR AND OVERRIDE MODULE
Mounting
1. Loosen the cover-locking screw with the Allen wrench
provided and remove the T7147 cover.
2. Run wire to the selected location.
3. Thread wire through T7147 base semicircular hole.
4. Make connections to T7147 (see Wiring section).
5. If air drafts occur through the wall opening, eliminate
them with suitable insulation material.
6. Four mounting screws are provided:
a. 2 self-tapping type for wall mounting.
b. 2 for outlet box mounting.
7. Select the proper screws for the application.
8. Fasten the T7147 to the wall or outlet box with screws
through the T7147 base assembly mounting holes.
(See Fig. 3).
9. Replace the cover assembly and tighten the cover-
locking screw.
WALLPLATE
MOUNTING
SCREW (2)
MOUNTING
TAB
(2 INSIDE
COVER)
Fig. 3. Mounting the T7147.
3
OUTLET BOX
MOUNTING
TAB SLOT (2)
WIRING
TERMINALS
COVER
LOCKING
THERMOSTAT
SCREW
M17884
63-4065—1
Advertisement
