Niles SVL-4 Installation & Operation Manual page 11

S S
P E A K E R
3. Make the connections to the SVL-4. The amplifier/speaker
connectors on the SVL-4 are removable. If you wish, you
may remove the SVL-4's connectors to facilitate installation
[see (Figure 3)]. Strip 3/8" of insulation from the end of
each wire. Tightly twist the end of each wire until there are
no frayed ends. Insert each wire into the appropriate hole on
the connector terminals. Be certain that proper phasing is
observed — connect the positive terminals on the SVL-4 to
the positive terminals on the amplifier and speakers and the
negative terminals on the SVL-4 to the negative terminals on
the amplifier and speakers. Re-install the connectors if they
were removed. See (Figure 4).
4. Locate the pre-printed Room Labels. Affix the appropriate
label to the recessed area over each ON/OFF selector button.
Figure 3
Removing the Connectors
/ V
E L E C T I O N
C
O L U M E O N T R O L
Installing the Connectors
S
Y S T E M
Figure 4
1
0