Setup; Figure 3-3. Rear Chassis Connections - ADTRAN MX3216 System Manual

MX3216 System Manual

Setup

The following steps outline the rear chassis connections (see
BNC Connectors
1. Connect the incoming DS3 (the DS3 from which the DS1s are dropped) to the DS3 A
BNCs.
2. Connect the outgoing DS3 to the DS3 B BNCs.
3. Connect the DS1s using the amphenol connectors on the rear panel.
For more information, refer to
The default mapping of the 3/1 cross-connect is for all the DS1s to
pass straight through from one DS3 to the other. No DS1s are
dropped to the DSX-1 ports or the expansion slots. If needed, re-
establish the default mapping through selecting the Restore Map to
Factory Default option in the
Starting from the default mapping, use the Quick Setup menu to drop the DS1s. Select each
DS1 port (1–16) to which a DS1 needs to be dropped from the incoming DS3. For each DS1
port, select the DS1 in DS3 A to be dropped to that DS1 port.
Figure 3-4 and Figure 3-5
Figure 3-4 shows the Quick Setup menu before any DS1s have been dropped.
shows the same menu after DS1s 12–15 have been dropped from DS3 A to DS1 Ports 1–4,
respectively. DS1s 1–11 and 16–28 continue through from DS3 A to DS3 B. DS1s 12–15 in
DS3 B are now filled with AIS going out DS3 B.
3-4

Figure 3-3. Rear Chassis Connections

"Rear Chassis Connections"
NOTE
"Cross-Connect Menu"
show an example of setting up a drop and continue application.
Figure 3-3).
Amphenol Connectors
on page 4-7.
on page 6-35.
Figure 3-5
61189008L1-1B