Table of Contents
Advertisement
To select a computer using hotkeys
Using hotkey combinations, you can quickly switch the keyboard, video
monitor(s), mouse and speakers and USB peripherals to any computer channel.
There are two mains ways to use hotkeys: Standard and Additional.
Standard hotkey press combinations
The standard hotkey press combinations allow you to change channels with the
minimum of keypresses:
1 Simultaneously press and hold
2 While still holding
and
channel address (or the TAB key), then release all of the keys.
Note: The numbers on your keyboard's numeric keypad are not valid, use
only the numeral keys above the QWERTY section.
The ports (KVM, audio and/or USB) that are switched using this method
depend upon the switching mode that is currently set using the
buttons.
The range of standard hotkey combinations are as follows:
Note: If your hotkeys have been changed, substitute them for
the examples given here.
Selects channel 1
Selects channel 2
Selects channel 3
Selects channel 4
Isolates the user console from all channels
Selects the next channel (see note
What are hotkeys?
The
and
keys when pressed in combination are called 'hotkeys' and
they signal to the AV4PRO-DP unit that you wish to control it, rather than the
computer. However, if these particular hotkeys clash with another device or
program, you can change them to a different combination within
the
Configuration
menu.
and
(or other hotkeys, if altered).
, press the number key of the required
front panel
and
)
Additional hotkey press combinations
In addition to the standard hotkey press combinations (shown left), you can also
add additional keypresses in order to determine which peripherals are switched:
1 Simultaneously press and hold
2 Press and release a command key:
to switch all peripherals
to switch only the keyboard, video and mouse
to switch only the speakers
to switch only USB1 and USB2
3 Press and release the required channel number (
above the QWERTY section).
4 Release
and
in
The appropriate peripherals will change to the chosen channel.
Note: Regardless of which peripherals were switched, the front panel
indicators will continue to show the switching mode that was last
determined using the front panel controls.
Choosing which computers are accessed when using hot keys + tab
The computer channels that are visited when you use the hot keys + tab (or
mouse buttons/autoscan) are determined by a setting within the Configuration
menu:
Configuration
1 Enter the
2 Press
and then press either:
to choose Cycle all ports, or
to choose Cycle only active ports
3 Press
to accept the setting and return to the main menu section.
4 Press
and then
and
.
to
.
menu.
to exit the menu and save changes.
using only the keys
18
Advertisement
Table of Contents
