Miele KFN 14842 SD ed Operating And Installation Manual page 56

Changing the door hinging
^ Remove cap l from the bush in the
door and refit on the opposite side.
Refitting the lower door
^ Remove cover a by pulling it
forwards.
^ Pull cover b off.
^ Screw the foot into hinge pin c as far
as it will go.
^ With the help of another person,
carefully tilt the appliance backwards
and pull hinge pin c out.
56
^ Take care not to lose hinge bush d.
^ Undo screws e and take hinge plate
f off.
^ Remove cover g and undo the
screws. Refit the screws and cover on
the opposite side.
^ Refit hinge plate f onto the other
side using the 2 outer screws. To
make it possible to align the door
later, do not replace the centre
screw at this stage.
^ Unscrew part h from hinge plate f,
rotate it by 180° and refit into the hole
on the opposite side of the hinge
plate.
^ Refit cover b on the opposite side.
^ With the help of another person,
carefully tip the appliance back and
refit hinge pin c from below into
hinge plate f. The notch at the
bottom of the hinge plate should face
forwards.
^ Replace hinge bush d on hinge pin
c.
^ Refit cover a.
^ Place the lower door onto hinge pin
c from above.
^ Close the lower appliance door.