Miele T 4672 C Operating Instructions Manual page 16

How to dry correctly
Selecting Extra options
^ Select the Extra option you want.
Indicator light on = Extra option is
selected
To select delay start
^ See "Delay start".
E Start the programme
The indicator light for the Start/Stop
button will flash when a programme is
being selected. The flashing indicates
that a programme can be started.
^ Press the Start/Stop button.
The indicator light for the Start/Stop will
then change from flashing to being on
constantly.
Programme start will appear in the
display, followed by Drying and the
programme duration.
With sensor drying programmes, e.g.
Machine iron , Hand iron , etc. the drying
level reached will be shown in the
display later on.
16
Before the end of a programme
There is a cooling down phase at the
end of the drying sequence: Cool down
will appear in the display. The
programme will not finish until the
cooling down phase has been
completed.
There is no cooling down phase at the
end of the following programmes:
Woollens hand care, Smoothing.
At the end of a programme
Anti-crease (if selected) and Finish will
appear in the display to indicate that
the programme has finished. The
buzzer will sound (if selected).
F Remove the laundry
^ Press the Door button to open the
drum door.
^ Remove the laundry.
Make sure that the drum is empty. If
items are left in the dryer, they could
be damaged by overdrying when
the dryer is next used.
If the appliance is switched on and the
door is opened, the drum lighting will
come on. It will go out a few minutes
later to save energy.
^ Switch the dryer off by pressing the
l-On/0-Off -button.
^ Clean the fluff filters.
^ Close the door.
^ Empty the condensed water
container (unless the dryer is
connected for external drainage).