Building In The Appliance - Miele KDN 9713 iD Operating And Installation Manual

Building in the appliance

Building in the appliance
^ Attach sealing strip a to the door
opening side so that it sits flush at the
front with the side of the appliance. If
necessary the sealing strip can be
trimmed to size along the lower edge
of bracket b.
^ Remove covers c and d.
^ Secure bracket b with screws e
(4.8 x 16 mm).
^ Push the appliance into the
building-in niche, leaving a gap of
approx. 4 mm.
Take care not to trap the mains
cable.
42
^ Push in the appliance until the front
edges of bracket b and hinge plates
f and g are flush with the front
edge of the housing.
^ Align the appliance height from
above on both sides using adjusting
screw h.
^ Carefully unscrew adjusting screw i
in the middle of hinge plate j until it
touches the side wall of the furniture
housing unit.