Miele KDN 12823 S Operating And Installation Manual page 42

Changing the door hinging
^ Fit hinge plate c onto the opposite
side and secure it with screws d.
If necessary drill pilot holes for the
screws or use a battery operated
screwdriver.
^ Fit covers a and b to their opposite
sides.
^ Align the door with the appliance
housing using the long slots in the
lower hinge plate. Then tighten the
screws.
42
Refitting the handle:
Please make sure you follow the
instructions below carefully when
you refit the handle. The door seal
will be damaged if the handle is
fitted incorrectly.
^ Loosely attach the handle to the
opposite side of the door with the two
front screws b.
Mounting plate c must be positioned
on the side of the door so that when the
door is closed it is flush with the side of
the appliance.
If this is not the case,
^ tighten both grub screws a with a
suitable allen key until mounting plate
c lines up correctly.
^ Then tighten all 4 fixing screws b.
^ Slide the side section of the handle
d into the guides on the mounting
plate until it clicks into place.