Miele FN 4957 S ed-1 Operating And Installation Manual page 37

^ Open the door, tilt it downwards and
take it off.
^ Remove cover f, and unscrew hinge
bracket g.
^ Fit bearing bolt h in the second hole
of hinge bracket g.
^ Refit bracket i and cover j turned
through 180° on the opposite side.
^ Screw hinge bracket g into the
opposite side.
The M4 screw has to be screwed into
the left hole of the hinge bracket.
^ Turn cover f through 180°, and fit it
on the other side.
^ Remove spacer k with a screwdriver
and refit it on the opposite side.
^ Remove plug l from the door
bearing bush in the door and refit on
the opposite side.
^ Hang the door on bearing bolt h and
then close the appliance door.
Changing the door hinging
In the following illustration the door
is not shown in the closed position to
make it easier to see what happens
next.
^ Turn door support b through 180°,
pull bearing bolt a out, and then fit
both parts into bearing block f:
To do this push bearing bolt a the
other way round through bearing
block f into door support b. Swing
the door support in, push upwards
and re-assemble with screw c.
37