Programme Sequence Indicator Lights; Time Display; Light Ring - Miele G 674 Operating Instructions Manual

Programme sequence indicator
lights (16)
The "Wash/Rinse" indicator light comes
on in the Pre-wash, Main wash, Interim
rinse and Final rinse stages of a pro-
gramme.
The "Drying" indicator light comes on
during the drying stage of the pro-
gramme.

Time display (15)

The running time of the programme se-
lected shows in the time display (15) in
hours and minutes before a pro-
gramme is started. During a pro-
gramme the time left until the end of
the programme is displayed. The "Time
left" indicator light next to the time dis-
play lights up.
The time displayed in the time display
may vary with the same programme.
This is partly because of the water inlet
temperature at each intake and partly
because of the amount of crockery
being washed.
When the dishwasher is first switched
on the display shows an average time
value for a cold water intake.
Values shown in the programme chart
refer to normal loads and average tem-
peratures and are for guidance only.
Operating the dishwasher
Each time a programme is run the elec-
tronic unit takes into account the new
conditions and calculates the pro-
gramme time required. This new figure
is then displayed when this programme
is next selected.

Light ring (18)

The light ring illuminates when the dish-
washer is switched on and goes out 5
minutes after a programme has fin-
ished.
It will come on again for 10 minutes if a
button on the control panel is pressed
or if the programme selector is moved.
If the "Delay Start" function is activated
the light ring will go out 10 minutes
after you have set the delay start time.
It will come on again for 10 minutes if a
button on the control panel is pressed
or if the programme selector is moved
during this delay period.
35