Increasing The Water Intake Time - Miele G 663 Operating Instructions Manual

Increasing the water intake time

The water intake time is set to "normal" at the factory. If the water pressure is lower
than 1.0 bar, too little water will flow into the wash cabinet (see "Checking the
water level"). In this case the water intake time must be increased.
Procedure...
Open the door.
Switch the dishwasher off using the "Off" (
pad.
Press touch pads
the same time switch the dishwasher on by pressing
the "On" (g) touch pad.
Release touch pads
Note: If a different indicator light is flashing,
the process must be repeated.
The following indicator lights may also light up, if:
– you have not yet added rinse aid or if rinse aid
needs replenishing,
– drying heat has been switched off (see "Additional
functions"),
– water intake is set to extended time,
– the buzzer at the end of a programme has been set
to deactivated (see see "Additional functions").
b d
and and whilst doing so at
b d
and again.
Solving problems
n
) touch
o
Rinse aid
n
lit up flashes
On Salt
On Salt +
b
d
e
c
59