External Water Softening System - Miele G 1570 Operating Instructions Manual

External water softening
system
If your dishwasher is connected to an
external water softening system which
uses salt to reactivate, you will still need
to programme the dishwasher to the
correct water hardness level to achieve
good cleaning results.
^ Set the water softener unit of the
dishwasher to the water hardness
level of the water which is supplied
from the external water softening
system. If you do not know what it is,
set the dishwasher for 8 °d
(1.4 mmol/l).
^ Switch the dishwasher off with the Off
button o.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on with the On
button g.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Tab button twice.
The "3 in 1" indicator will flash briefly
twice at intervals.
Before using for the first time
The number after the p in the display is
the water hardness level in °d (see
chart).
^ Use the programme selector button
to select the value which
corresponds to your water hardness
level.
Each press on the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
^ Switch the dishwasher off with the Off
button o.
If you disconnect the dishwasher
from the external water softening
system, set the value to P0.
15