Grease Filter - Miele DA 5100 D EXT Operating And Installation Instructions

Important for appliances with
lacquered housing
(special finish)
It is very difficult to clean this type of
surface without causing minor marks to
the surface material. This can become
particularly noticeable with darker
colours and if there is halogen lighting
in the kitchen.
Controls
The controls may suffer
discolouration or damage if soiling is
left on them for too long. Remove
soiling straight away.
Observe the General notes on cleaning
earlier in this section.
Do not use stainless steel cleaning
agents on the controls.
Glass surfaces
^ Glass surfaces can be cleaned using
a proprietary non-abrasive cleaning
agent designed specifically for use
on glass.
Do not use:
– abrasive cleaning agents, e.g.
powder cleaners and cream
cleaners,
– abrasive sponges, e.g. pot scourers
or sponges which have been
previously used with abrasive
cleaning agents,
– oven sprays.
Cleaning and care

Grease filter

The re-usable metal grease filter in the
appliance removes solid particles from
the kitchen vapours (grease, dust, etc),
preventing soiling of the cooker hood.
The grease filter should be cleaned
regularly (at least every 3-4 weeks) to
avoid a built-up of fat, but always clean
immediately if the operating hours
control indicator lamp lights up red.
,
An oversaturated filter is a fire
hazard.
^ To take out the grease filter, release
the locking clip on the filter, lower the
filter 45°, unhook it at the back and
remove it.
To avoid damaging the filter or the
hob below, make sure you hold the
filter securely at all times when
handling it.
23