Download Print this page

Advertisement

Operating and installation instructions
Cooker hoods
DA 5100 D
DA 5100 D U
DA 5100 D EXT
GWOZHr
To avoid the risk of accidents
or damage to the appliance
it is
to read these
instructions before it is installed
or used for the first time.
M.-Nr. 06 935 880

Advertisement

loading

Summary of Contents for Miele DA 5100 D

  • Page 1 Operating and installation instructions Cooker hoods DA 5100 D DA 5100 D U DA 5100 D EXT GWOZHr To avoid the risk of accidents or damage to the appliance it is to read these instructions before it is installed or used for the first time.
  • Page 2: Table Of Contents

    ......... . 3 .
  • Page 3 Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. disposal, and can normally be They are, however, essential for the recycled.
  • Page 4 This appliance complies with all Before connecting the appliance to relevant local and national safety the mains supply, make sure that requirements. Inappropriate use the voltage and frequency details given can, however, lead to personal injury on the data plate correspond with the and damage to property.
  • Page 5 Overheated oil and fat can These models may only be combined ignite and could set the cooker hood on with a Miele external motor. fire. In countries where there are areas Do not use the cooker hood without which may be subject to infestation the grease filter in place.
  • Page 6 All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders’ merchants. The appliance must not be connected to a chimney or vent flue which is in use.
  • Page 7 Harmful gases such as carbon monoxide could be drawn out of the chimney or extraction ducting back into the room with potentially fatal consequences. In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the...
  • Page 8 The Miele Control module DSM 400 offers the possiblity of combining such components with the cooker hood (see "Operation with Control module DSM 400").
  • Page 9 The cooker hood works with (...U models only) (excluding ...U models) The air is drawn in and cleaned first by the grease filter and then by a . The cleaned air is then The air is drawn in, cleaned by the recirculated back into the kitchen grease filter and then directed outside.
  • Page 11 The indicator lamp for the operating hours control lights up when the grease filter needs to be cleaned. Additional feature of the DA 5100 U: The indicator lamp lights up when the charcoal filter used in recirculation (...U models only) mode needs to be replaced.
  • Page 12: Intensive Setting

    The indicator lamp will come on. If the cooker hood has been connected to a window contact switch via the Miele DSM 400 control ^ Press the run-on option control for module, then the fan cannot be approx. 10 seconds. The first fan switched on if the window is shut.
  • Page 13: Run-On Option

    It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the The indicator lamps for fan power levels air, whether you are using air extraction I and IV will flash if the automatic or recirculation mode.
  • Page 14: To Switch The Lighting On

    The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting control to ^ Pressing the On/Off control will switch switch on the hob lighting.
  • Page 15 The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set already used: The operating hours counter tells you when the grease filter or charcoal filter needs to be cleaned or replaced. ^ Press the On/Off touch control to switch the fan on.
  • Page 16 You can set the operating hours counter for the grease filter to suit the control lamps show the time type of cooking you do. which has been set: – Select a short time if you roast or fry 1st lamp from the left = 20 hours a lot.
  • Page 17 ^ Confirm the selection by pressing the operating hours control. (...U models only) All the indicator lamps will go out. The charcoal filter is needed for If you do not confirm your selection recirculation mode. within 4 minutes, the cooker hood will automatically revert to the "old"...
  • Page 18 To check the percentage of time set already used: ^ Press the On/Off touch control to switch the fan on. ^ Press the operating hours control twice in succession, and hold it pressed in. The indicator lamp will light up One or more of the indicator lamps for controls will flash.
  • Page 19 The surfaces and controls are susceptible to scratches and Stainless steel surfaces can be cleaned abrasions. Please observe the using the Miele E-cloth or with a following cleaning instructions. proprietary non-abrasive cleaning agent designed specifically for use on ^ All external surfaces and controls can stainless steel.
  • Page 20 The re-usable metal grease filter in the appliance removes solid particles from (special finish) the kitchen vapours (grease, dust, etc), It is very difficult to clean this type of preventing soiling of the cooker hood. surface without causing minor marks to the surface material.
  • Page 21 ^ Clean the filter ^ After replacing the grease filter, press with a soft nylon brush, the operating hours control for warm water and a little washing up approx. 3 seconds to reset the liquid. operating hours counter. place the filters The indicator lamp will go out.
  • Page 22: Grease Filter

    – if it is no longer effective in absorbing New filters can be purchased from kitchen odours. your Miele dealer or from the Miele Spare Parts Department. It should, however, be replaced at least See back cover for contact details, every 6 months.
  • Page 23 Before any cleaning or maintenance work, the cooker hood must be disconnected from the mains supply. Ensure that: – it is switched off at the isolator, or – the fuse is withdrawn from the fused spur connection unit, or – the mains fuse is disconnected, –...
  • Page 24 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
  • Page 25 DA 5100 D, DA 5100 D EXT appliance: (Ceiling fixing viewed from above) 550 mm above electric hobs and...
  • Page 26 Before installation, it is important to read the information given on the following pages as well as the "Appliance dimensions" and the for securing the tower. "Warning and Safety instructions" at the beginning of this booklet. This is particularly crucial when using the cooker hood at the same time as a heating appliance that relies on oxygen from the same...
  • Page 27 If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to install and local safety regulations a residual current device (RCD) with a...
  • Page 28 The Miele DSM 400 control module can If the control module is be used to combine the cooker hood disconnected in order to operate the with other components. cooker hood without the window It enables the following: contact switch (e.g. after moving...
  • Page 29: Installation Instructions

    The control module can be used to switch on the cooker hood lighting and also to dim it (depending on model) via a light switch in the house. The control module is fitted in the tower after the cover plate has been unscrewed from the ceiling.
  • Page 30 – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away at at least 1 cm toxic fumes, please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as...
  • Page 31: Condensate Trap

    Cooker hoods designed for use with an external motor (...EXT models) have an If the exhaust ducting is to run through integrated condensate trap. rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to (optional accessory) be addressed.
  • Page 32 DA 5100 ....36 kg DA 5100 D U....36 kg DA 5100 D EXT .
  • Page 36 Alteration rights reserved / 3506 M.-Nr. 06 935 880 / 00 en - GB...