Miele KWFN 8705 SE ed Operating And Installation Instruction page 46

In the following illustration the lower
door is not shown in the closed
position to make it easier to see
what happens next.
^ Turn door support b around, pull
hinge pin a out, and refit on the
opposite side.
^ Fit both parts into hinge plate f. To
do this push hinge pin a through
hinge plate f into door support b.
Swing the door support in, push
upwards and re-assemble with screw
c.
^ Align the lower door with the
appliance housing using the long slot
in hinge plate f. Then tighten screw
c.
^ Refit plinth fascia d, pushing it firmly
into position.
^ With the lower door open, secure
cover e to the front of the plinth
fascia.
46
^ Loosely screw the handles to the
opposite side of the doors.
The mounting plate must fit snugly to
the door housing. If it doesn't:
^ Tighten the two screws a with the
allen key provided as far as they will
go.
^ Tighten screws b.
^ Slide the side section of the handle
into the guides on the mounting plate
until it clicks into place.