Miele KM 84-2 Operating Instructions Manual page 24

Instructions for building-in
Instructions for building-in
2 zone Combiset
1 element
2 elements
3 elements
4 elements
5 elements
4 zone Combiset
1 elements
2 elements
3 elements
Combination
One 2 zone
+ one 4 zone
Two 2 zone
+ one 4 zone
Three 2 zone
+ one 4 zone
One 2 zone
+ two 4 zone
Two 2 zone
+ two 4 zone
Extractor (e.g. DA 8-2)
For building in between two appliances:
- Dimension B increases by 90 mm.
For building in at the end of a combination:
- Dimension B increases by 98 mm.
24
Depth Width
in (=
mm Dimen-
sion B)
in mm
490 265
490 558
490 851
490 1144
490 1437
490 560
490 1143
490 1728
490 851
490 1143
490 1437
490 1436
490 1729
Stick the seal provided
edge of the hob.
loosen
b
Appliance
c
Tensioning screw
d
Clamp
e
Worktop
f
Seal
Turn the tensioning screws
clamps on the appliance
anti-clockwise direction until a resist-
ance is met and turn the clamps to
the left.
Place the appliance into position,
turn the clamps and tighten the ten-
sioning screws until the clamps
press into the worktop
Connect the appliance to the elec-
tricity supply.
When building-in several Combiset
units, a spacer bar must be fitted be-
tween the units. It is supplied with its
own installation instructions.
f
under the
tighten
c
in the
b
in an
e
.