Miele KM 5731 Operating And Installation Instruction page 67

Making the worktop cut-out and
building in the hob
Granite and marble worktops
g
0 50
e
e Worktop
f Hob
g Gap
Corner radius of the worktop ß R4
0 f
2
13
^ Make the worktop cut-out as shown
in the drawings.
^ Feed the hob connection cable down
through the cut-out.
^ Centre the hob f in the cut-out.
^ Connect the hob to the mains.
^ Check that the hob works.
^ Seal the remaining gap g with a
silicone sealant that is heat-resistant
to at least 160 °C.
As the ceramic glass and the
worktop cut-out have a certain
dimensional tolerance, gap g can
vary (min. 2 mm).
Installation
67