Miele DA 362 Operating And Installation Manual page 24

^ Secure the cooker hood to the frame
using 3.5 x 16 mm screws.
^ Secure the vent ducting to the
exhaust stub with a hose clip and
connect to the venting system (see
"Connection for air extraction").
If site conditions are not suitable for the
cooker hood to be used for air
extraction, the appliance must be
connected for recirculation.
The following parts, available through
your dealer or from the Miele Spare
Parts Department are required for
operating the appliance in recirculation
mode:
– Conversion kit for
recirculation mode
(C 125 mm):
Exhaust grille, ducting,
hose clip
– 2 charcoal filters (see
"Technical data")
24
^ When fitting the cooker hood in a wall
unit the exhaust grille b has to be
fitted in the top of the wall unit.
^ The exhaust stub a and the exhaust
grille b are joined together using a
suitable hose or flexible ducting c. If
the front of the unit is ceiling height
(i.e. extractor canopies, ceiling
mounted units) then an appropriate
cut-out must be made in the front
panel d.
When fitting the exhaust grille make
sure that the slats in the grille point
towards the centre of the room and
not directly towards a wall or the
ceiling.
^ Install the charcoal filters (see
"Cleaning and care").