New Construction Installation - Triad InRoom Bronze PowerSub Installation Manual

4
16 inch on center studs
To Amplifiers
Step Three - Wire
Attach the wires from the source to the speaker.
You're done! Now the sheet rock people can sheet rock directly to the NCB for
a clean look. When you're ready to install the speaker, refer to step two of the
"Retro-fit Installation" section of this manual.

New Construction Installation

Tools you'll need:
Power Screw Driver or Hammer
Wire Stripers
Level
Pencil or Pen
Supplies you'll need:
Triad (NCB) New Construction Bracket
Screws or Nails for attaching NCB to studs
Step One - Mark
Locate the area where the speaker will be placed
on the stud wall keeping in mind that the speaker
when installed will take up the full wall cavity
within the NCB location (i.e. free from electrical
wires, water pipes, etc.).
Position the bracket between the desired two
studs. Take special note of the location, of the
direction arrows silk screened to the inside of the
bracket. As you face the wall these arrows should
be facing into the room.
With the level resting on top of the NCB make
sure the bracket's top is level and mark with
pencil, the location where the NCB touches the
studs.
Step Two - Attachment
Re-check NCB alignment with marks from step
one, and attach screws through attachment holes
on NCB. Re-check squareness and adjust if
necessary.