Triad InRoom Bronze PowerSub Installation Manual page 12

Triad Platinum PowerSub
Amplifier:
Features & Adjustments
Bass Extension (Hz)
This control adjusts the Bass Extension Level.
This determines how low (lowest frequency note) the
speaker will play. For THX settings, set the level at the
THX mark. If low frequency extension is desired or
when using multiple subs, set level at 18 Hz.
Input Level
This control adjusts the PowerSub's loudness. Use this
adjustment to match the PowerSub's loudness to
your front LCR's or satellites. For THX settings, set the
level at the THX mark. When using multiple subs this
level should be set closer to the MIN mark.
Low Pass Filter (Hz)
This control set the highest frequency (note) that your
PowerSub plays which adjusts (blends) the crossover
point between the PowerSub and satellites. For THX
settings, set the level at the THX mark.
Phase Control
This adjusts the phase (timing) of the signal that is fed
into the Inputs. Use this to fine tune the musical
blend between the sub and satellites. Usually set at 0
or 180 degrees.
Mono/THX Input
Connect to this RCA jack input when using the
"sub out" from an THX Processor or THX Receiver.
Left & Right Inputs
Connect to these RCA jack inputs when using
pre-amp out from processors/pre-amps.
Left & Right Inputs - Using the PowerSub's Speaker
to Line Level Converter
These convert speaker level at your receiver or power
amp to the line level required for use in your
PowerSub's line level inputs.
35
32
BASS
27
EXTENSION
LEVEL (Hz)
22
18
MIN
INPUT
LEVEL
MAX
50
65
LOWPASS
80
FILTER (HZ)
110
180
0
PHASE
-90
CONTROL
-180
LINE LEVEL
INPUTS
LEFT
MONO
RIGHT
Converter Required for Speaker Level Inputs
See Owner's Manual
Powered Subwoofers by Triad
Made in the USA
11