Using The Controls; Switching On; Using The Remote Control - Toshiba 32AV503 Owner's Manual

00GB_AV505D_EngOM.book Page 10 Wednesday, November 28, 2007 2:36 PM
SETTING UP

Using the controls

Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
GREEN LED - Active standby (digital only)

Switching on

If the RED LED is unlit check that the mains plug is connected
to the power supply. If the picture does not appear press
the remote control, it may take a few moments.
To put the television into Standby press
control, the GREEN active standby LED will appear (see
'Software Upgrade' section) next to the RED for a few moments
then disappear. To view the television press
picture may take a few seconds to appear.

Using the remote control

Press M on the remote control to see the menus.
In digital mode the menu bar at the top of the screens will
show three different topics shown in symbols. As each symbol
I i
is selected by pressing the or button on the remote control,
its respective options will appear below.
In analogue mode the menu appears as a list of five topics.
As each symbol is selected by pressing
ring on the remote control, its respective options will appear
below.
U
To use the options press the and
control to move up and down through them and Q,
select the required choice. Follow the on-screen instructions.
The functions of each menu are described in detail throughout
the manual.
To alter the volume press –
1
on
To alter the programme position press
Press MENU and
1
on the remote
options.
Press MENU to finish.
1
again. The
To select the external input, press
input source is selected as described on page 31.
Please always refer to the owner's manual of the equipment to
be connected for full details.
Please note: Inserting the headphone plug will mute the sound
from all speakers.
I i
or on the navigation
u
button on the remote
I i
or to
10
COMMON INTERFACE
The Common Interface
is for a Conditional
Access Module (CAM).
Contact a service
provider.
Headphone jack
RED LED – Standby Standby
GREEN LED – Power on
Using the controls
2
+.
b p B
I i U u
, , or to control the sound and picture
o
until the appropriate
.