Table of Contents
Advertisement
00GB_AV500P_EngOM.book Page 10 Tuesday, December 11, 2007 5:40 AM
SETTING UP
Using the controls
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
Switching on
If the RED LED is unlit check that the mains plug is connected
to the power supply. If the picture does not appear press
the remote control, it may take a few moments.
To put the television into Standby press
control. To view the television press
take a few seconds to appear.
Using the remote control
To set up the television you will now need to use the on-screen
menus. Press M on the remote control to see the menus.
The menu bar at the top of the screens will show five different
topics shown in symbols. As each symbol is selected by
Y
y
pressing
or
on the navigation ring on the remote control,
its respective options will appear below.
<
To use the options, press
on the navigation ring to move
down through them and Q,
Y
or
choice. Follow the on-screen instructions. The functions of
each menu are described in detail throughout the manual.
RED LED – Standby
GREEN LED – Power on
To alter the volume press –
1
on
To alter the programme position press
Press MENU and
1
on the remote
options.
1
again. The picture may
Press MENU to finish.
To select the external input, press
input source is selected as described on page 23.
Please always refer to the owner's manual of the equipment to
be connected for full details.
Please note: Inserting the headphone plug will mute the sound
from all speakers.
y
to select the required
10
Headphone jack
Standby
Using the controls
2
+.
b p B
.
I
i
U
u
,
,
or
to control the sound and picture
o
until the appropriate
Hide quick links:
Advertisement
Table of Contents
