IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. The Loose Parts Pack is packaged underneath the deck of the product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct...
Page 3
9. Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo re- placement cable. 10. Always wind cable carefully, avoiding kinking.
Assembly Instructions • The Loose Parts Pack is packaged underneath the deck. Assembly of Lower Handles to Deck 1. Place the bolt (A2) through the hole in the lower handle (A1) until the lower handle fits into the recess (A3) 2.
grassbox full Cutting Height Adjustment (K) & (L) • Height of cut is adjusted by raising or lowering the Front and Rear Wheels. • There are five heights of cut on this product. • NOTE A medium height of cut is recommended for most lawns.
1. Start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already cut. (S) 2. Mow twice a week during the growing season, your lawn will suffer if more than a third of its length is cut at one time and this may also result in poor collection.
Switch off, wait until the blade has stopped rotating and disconnect from the mains electricity supply BE- FORE attempting to remove or refit the blade. Always handle the blade with care - sharp edges could cause injury. USE GLOVES. Removing the Blade 1.
Cleaning • USE GLOVES • IMPORTANT:- It is very important that you keep your lawn- mower clean. Grass clippings left in any of the air intakes or under the deck could become a potential fire hazard. 1. Remove grass from under the deck with brush. (V1) 2.
1. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. 2. Always use genuine Spare Parts. 3. Prepacked spares are available from most Husqvarna UK Ltd. stockists. 4. Your product is uniquely identified by a silver and black product rating label 5.
Need help?
Do you have a question about the VENTURER 32 EM032 and is the answer not in the manual?
Questions and answers