Battery Replacement; Troubleshooting - Honeywell Enviracaire 17005 Owner's Manual

Battery Replacement

Remote control handset: Two 1.5V AAA size batteries. Replace as needed.
Control Panel Battery backup: Replace battery with Panasonic CR 2032, 3V only. Use of
another battery may present a risk of fire or explosion. Replace when Battery Low icon
appears on viewing screen (
while replacing battery to prevent loss of customized
programs. To replace battery, locate battery door on control
panel. Use a flat head screwdriver to gently pry up both
ends of the battery door (Fig. 10). Carefully remove battery
holder from unit. Make sure that the (+) sign on the battery
is facing up in the battery holder before returning the new
battery to the unit. Dispose of used battery promptly. Keep
away from children. Do not disassemble and do not
dispose of in fire.
Storage
If you store your Honeywell HEPA air cleaner for more than 30 days, we recommend:
• Removing both the primary HEPA filter and the activated carbon pre-filter from the unit.
• Discarding the pre-filter.
• Wrapping the HEPA filter in an air-tight plastic bag or plastic wrap. Be sure that the
filter is totally sealed.
• Remove and store batteries. Keep batteries away from children. NOTE: Removing
control panel battery will erase customized programs and times.
To restore the air cleaner to service, unwrap the HEPA filter, install a new
activated carbon pre-filter, reinstall both filters in the air cleaner and reinstall batteries. See
"How to Replace the Filters", and "Battery Replacement" section for proper installation.

Troubleshooting

• For optimum performance, start on HIGH for a few minutes, then adjust to desired
speed.
• This product may emit a "new" smell which will disappear over a relatively short period
of operation.
• Check to make sure that the power cord is correctly connected to the outlet.
Note: The unit can not be programmed unless it is plugged into the outlet.
• Test that the outlet is functioning properly using another appliance or lamp.
• Check the fuse or circuit breaker. The outlet may be overloaded if other appliances are
also in use. Determine and correct the cause of the overload.
• If none of the above procedures restore operation, call Honeywell at (800) 332-1110 or
e-mail us at service@honeywell.com for technical assistance. If the problem can not
be resolved, see warranty terms and conditions in this owner's manual. Do not attempt
to repair the unit yourself, as it may cause injury, and the warranty does not cover
damage resulting from unauthorized attempts to repair or from any use not in
accordance with this manual.
). Keep unit plugged in
Fig. 10
hours
filter
speed
minutes
set
program