Wheelock RPS-2406-I Installation Instructions

273 Branchport Avenue
Long Branch, NJ 07740
(800) 631-2148
www.wheelockinc.com
Use this product according to this instruction manual. Please keep this instruction manual for future reference.
MODEL NO: RPS-2406-I
DESCRIPTION:
24VDC regulated and filtered power supply, specifically designed to power Wheelock's 24VDC Industrial Appliances. Provides
overload and short circuit protection with automatic shut down, and reset.
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT.
NOTE: All CAUTIONS and WARNINGS are identified by the symbol
SPECIFICATIONS:
Output Voltage:
Screw Terminals:
INSTALLATION:
CAUTION: Make sure power supply is not plugged in during installation and wiring.
1. Check the voltage and current ratings of all appliances and other devices to be connected to the RPS-2406-I. Make sure the total
current does not exceed 600mA.
2. Wire the RPS-2406-I to the signaling system. Typical wiring is shown in Figure 1. Note that two isolated "spare" terminals are
provided on the RPS-2406-I for convenient wiring tie points.
RPS-2406-I
(BACK VIEW)
SPARE
POWER CORD
TO 117VAC
3. Using the mounting screws provided, mount the power supply to a secure wooden surface. For other surfaces, appropriate
mounting hardware should be used. See Figure 2.
4. Plug in the power supply cord to a 117VAC outlet and test the signaling system.
Copyright 2002 Wheelock, Inc. All rights reserved.
Thank you for using our products.
INSTALLATION INSTRUCTIONS
24 Volts
Regulation: +/-5%
Ripple Voltage: 10mVRMS
Output Current: 600mA Maximum (Do not overload)
Input Voltage: 117VAC, +10%, 60Hz
Duty Cycle: Continuous
Maximum Wire AWG #16
Minimum Wire AWG #24
24VDC
+
-
SYSTEM CONTROL
RELAY OR SWITCH
24VDC
SIGNAL(S)
Figure 1:
24VDC, 600mA
POWER SUPPLY
. All warnings are printed in bold capital letters.
+
-
WIRING TO
SIGNALING
SYSTEM
Figure 2:
Sheet 1 of 2
P81634 B