Table of Contents
Advertisement
AIS: No valid ROT
35 (*)
Information
NOTE: Alarm – Messages marked with asterisk (*) will appear on standard workboat
installations due to missing sensor input devices
AIS: BATTERY SOON
53
LOW
AIS: PRESS ENTER TO
55
EXIT 1W/AUTO TX
MODE
AIS: ENTER MMSI
56
NUMBER
Installation Manual
No ROT indicator is
Reaction: The transponder unit continues operation
used.
Remedy:
No valid data from
The sentence for ROT cannot be received. If a Rate Of Turn
external sensor
indicator is not in use, then it suffices to just acknowledge the
alarm. The Alarm Status will store the information that no ROT
sensor is available. Otherwise, check the sensor and the cabling.
Check if the system that delivers the data is working. Check the
baud rate settings of the sensor inputs. AIS requires the protocol
NMEA 0183 V3.0!
Battery is soon out
Reaction: Own ship data is lost after powering on/off the system.
of capacity
Remedy: consider to contact Technical Support for additional help
Reaction: Conditions for enabling 1 Watt TX power are not valid.
This means that:
Conditions for
enabling 1 Watt
TX power are not
Remedy:
valid
Reaction: During the initial boot or after "factory settings" the user is
No valid MMSI
asked to enter a valid MMSI. As long as this is not done, the system
entered.
does not transmit.
Remedy: Enter a valid MMSI
x
the speed is >3kn and / or
x
the navigational status is NOT moored / at anchor and / or
x
the ship type is NOT "Tanker"
x
Check the conditions (SOG, Navstat, Shiptype)
x
if GPS is valid ( a invalid GPS causes also this alarm)
22
Y1-03-0219 Rev. A
Advertisement
Table of Contents
