Mitsubishi Electric DLP 740 Series Basic Owner's Manual page 8

8
1. Basic Setup and Operation
Setting Up and Using TV Inputs, continued
Settin g Up Inputs with Auto Input Sensing
Connection information starts on page 12 . Learn more
about Auto Input Sensing on page 26 .
1.
Power on the TV.
2.
Power on the devices to ensure detection.
3.
Connect one device to the TV, making note of the
TV input jack.
The TV will display the New Device Found screen if
the connection type is detectable.
4.
Highlight the device type in the on-screen list and
press ENTER. The name you select here will appear
in the Input Selection menu.
Sample New Device Found screen.
5.
Press EXIT to close the New Device Found screen.
6.
Repeat the preceding steps for each additional
device you want to add.
Selecting an In put to Watch
1.
Press INPUT.
2.
Press and to highlight an
input icon.
Sample Input Selection menu, DVD input selected
3.
Press ENTER to switch to the input.
Note: In most cases, to see a named icon for a con-
nected device (as in the samples), you must fi rst
assign a name either
• When the device is first connected and the
New Device Found menu offers a choice
of names.
• By using the Inputs > Name menu to
assign or change a name at any time after
the TV has detected the connection.
For assistance call 1(800) 332-2119
More About the Input Selection Menu
• To assign helpful names to the icons, see the
Inputs > Name menu.
To remove unwanted Antenna, Bluetooth ® , or HDMI
•
device icons from the Input Selection menu, see
the Inputs > Name menu.
• To rearrange the icons, use the Inputs > Order
menu.
Detailed information on using these menus
is in the supplemental Owner's Guide at
www.mitsubishi-tv.com.
Wa tching Broadcast TV
TV Connected to an Antenna or Direct Cable
Service (no cable box)
Note: Perform channel memorization to enable recep-
tion of digital channels. See page 7 .
1.
Press INPUT to display the Input Selection menu.
2.
Highlight the antenna or cable icon and press ENTER.
Sample Input Selection menu, antenna input selected
3.
To tune to a channel from the ANT input, use any of
these methods.
• Enter the channel number using the number
keys on the remote control and press
For a two-part digital channel, such as 3-1,
—
press 3 CANCEL 1
Press CH to change channels one channel at
•
a time.
Press and hold CH to speed through channels.
•
• Press LAST to return to the previous channel.
• Use the Fav (Favorites) feature to tune to up to
nine favorite channels. See the supplemental
Owner's Guide at .
Press GUIDE to display ChannelView channel
•
listings. Highlight a channel number, then press
ENTER to tune.
• Set up ChannelView custom channel banks
and use the CH key to tune within predefined
groups of channels.
ENTER
ENTER .
.