Setting Up Your Projector; Setting Up The Screen; Aspect Ratio; Screen Size And Projection Distance - Mitsubishi Electric HC9000D User Manual

Setting up your projector

Setting up the screen

Install the screen perpendicularly to the projector. If the screen can not be installed in such a way, adjust the
projection angle of the projector. (See page 12.)
• Install the screen and projector so that the projector's lens is placed at the same height and horizontal position of
the screen center.
• Do not install the screen where it is exposed to direct sunlight or lighting. Light directly reflecting on the screen
makes the projected images washed-out and hard to view.

Aspect Ratio

You can keep the image display area within the screen by setting Aspect Ratio in the Screen menu according to the aspect
ratio of the actual screen. Select Full screen when the aspect ratio of the screen is Full screen or Standard.
When setting Aspect Ratio to Full screen:
• 4:3 size movies are projected in the full screen.
• Set Aspect Ratio in the Screen menu to Full Screen when displaying Vista-size images. In this case, they are squeezed
horizontally.
• When Aspect Ratio in the Screen menu is set to Anamophic 1 and 480i/p, 576i/p, 720p, or 1080i/p signal is input, the part
for displaying subtitles is not projected. To display subtitles, reset Aspect Ratio to Full screen and adjust the image position
using Horizontal Position and Vertical Position in the Screen menu.

Screen size and projection distance

Refer to the following tables to determine the screen size and projection distance.
• The figures in the tables are approximate and may be slightly different from the actual measurements.
• The lens shift height and width show distances from factory default position.
When the aspect ratio of the screen is Full Screen
Screen (16:9)
Diagonal size Height (SH) Width (SW)
inch cm inch cm inch
50 127 25 62 44
60 152 29 75 52
70 178 34 87 61
80 203 39 100 70
90 229 44 112 78
100 254 49 125 87
110 279 54 137 96
120 305 59 149 105
150 381 74 187 131
200 508 98 249 174
• Projection distance changes according to the setting of Aspect Ratio in the Screen menu. The table above is in the case of "Full Screen. "
• Depending on the installation conditions, warm air that is emitted from the exhaust vents may flow into the intake vent,
causing the projector image stop.
Screen
L
Distance from Screen
Shortest (Wide) Longest (Tele)
cm inch m inch m
111 66 1.7 122 3.1
133 80 2.0 147 3.7
155 94 2.4 172 4.4
177 108 2.7 197 5.0
199 122 3.1 222 5.6
221 135 3.4 246 6.3
244 149 3.8 271 6.9
266 163 4.1 296 7.5
332 205 5.2 371 9.4
443 274 7.0 496 12.6
Screen width (SW)
Down shift
W1
Up shift
Right shift
Lens movable range
H1 W1
inch cm inch cm
25 62 20 50
29 75 24 60
34 87 27 70
39 100 31 80
44 112 35 90
49 125 39 100
54 137 43 110
59 149 47 120
74 187 59 149
98 249 78 199
EN-10
W1
Left shift