Page 3
Parts Note: Some parts shown are assembled to both sides of the trike. Handlebar Seat Seat Retainer Fork Straight Axle Rear Wheel 2 Hubcaps 2 Covers 2 Fork Covers Frame Cap Nut 2 Pedals Pedal Axle Cap Nut Assembly Tool Front Wheel 4 Pedal Hubs Part Not Shown: Label Sheet...
Rear Wheel Indented Side Down Straight Axle • Slide a hubcap (peg side up) onto the straight axle. • Slide a rear wheel (indented side down) onto the straight axle. Hole Straight Axle BOTTOM VIEW • Turn the frame upside down. •...
Page 5
Pedal Hub Pedal Axle Slot • Fit two pedal hubs onto the pedal axle tabs. Make sure the tabs fit into the slot in each pedal hub. Pedal Hubs Pedal Axle Hole • While holding the pedal hubs on the pedal axle, insert the pedal axle through the hole in the center of the front wheel.
Page 6
Fork Cover Pedal Axle • Place the front wheel assembly between the fork arms. Make sure the pedal axle fits into the groove at the bottom of each fork arm. • Place a fork cover over the pedal axle on one fork arm. •...
Label Decoration • Make sure the areas where the labels will be applied are clean and dry. Wipe your vehicle with a clean, soft, dry cloth to remove any dust or oils. • For best results, avoid applying a label more than once. •...
Removing the Seat Seat Retainer Tab Seat Retainer Tab • Turn the frame on it’s side. • Squeeze the seat retainer tabs toward one another and lift the seat from the frame. • Periodically, check the plastic parts and if broken or cracked, dispose of them properly.