Table of Contents
Advertisement
Troubleshooting (continued)
Problem
I cannot use the flash to
take pictures.
The flash will not charge.
Images cannot be played
back.
The playback image is
too dark even though I
used the flash.
The playback image is
blurred.
I cannot format the
SmartMedia™ card.
I cannot erase all the
frames.
Nothing happens when I
use the buttons and
switches.
The set date and time
disappears.
Causes
The mode dial has been changed to
another setting.
The flash is set to Suppressed Flash
mode.
You pressed the shutter button while
the flash was charging.
The camera is set to Suppressed Flash
mode.
The batteries are exhausted.
No images in selected folder.
The subject is too far away.
The lens is not clean.
The image is out of focus.
The SmartMedia™ card is
write-protected.
The frame is protected.
The SmartMedia™ card is
write-protected
Camera malfunction.
The mode dial is not at the correct
position.
The camera is in the Auto Power OFF
mode.
Both the batteries and AC adapter are
removed with the power still ON.
Set the mode dial to the correct setting.
Set the flash to Auto, Red-Eye Reduction or
Forced Flash mode.
Wait until charging is completed before pressing
the shutter button.
Set the flash to Auto, Red-Eye Reduction or
Forced Flash mode.
Replace with new batteries.
Select a different folder to play back.
Move closer to the subject.
(Approx. 1.3 ft.(0.4 m)-8.2 ft.(2.5 m))
Clean the lens.
Set macro photography to ON or OFF according to
the distance up to the subject.
Remove the write-protection.
Remove the write-protection.
Remove the write-protection.
Turn the power OFF and remove the batteries
once, and try again.
Set the mode dial to the correct setting.
Either press the shutter button fully down, or
change the mode dial setting.
Set the date and time again.
- 99 -
Remedy
E
Advertisement
Table of Contents
