Table of Contents
Advertisement
M
IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions
Guide below. If you still experience a problem, please contact Power Wheels
free at 1-800-348-0751 between 8 AM and 6 PM (EST) Monday through Friday. Or, contact your local
Power Wheels
Service Center list beginning on page 33.
Problem
Vehicle does not run
Problems and Solutions Guide
authorized service center. For the location nearest you, please refer to the Authorized
®
Possible Cause
Undercharged batteries
Charger is not working
Wrong type or improperly installed fuse
Tripped thermal fuse
Loose wire or loose connectors
Dead batteries
Electrical switch damage
Motor damage
Charge the batteries. New batteries should have been
charged for at least 18 hours before using the vehicle for
the first time. After first-time use, recharge the batteries for
at least 14 hours after each use. Never charge the batteries
longer than 30 hours.
Check all connectors. Make sure the battery connector is
tightly plugged into the charger connector, and that the
charger is plugged into the wall.
Make sure power flow to the wall outlet is "ON".
There is no sure way to tell if your charger is working unless
you have a volt meter. If you suspect there is a problem with
your charger, contact your local Power Wheels
service center. They can test your charger for you.
Make sure that the batteries have properly installed
Power Wheels
®
performance, do not use substitute parts.
A thermal fuse may "trip" and shut down operation of the
vehicle if the vehicle is overloaded or the driving conditions
too severe. The fuse will automatically reset itself after
approximately 25 seconds, allowing the vehicle to resume
normal operation. To avoid repeated automatic shutdowns,
do not overload the vehicle by exceeding the 130 lbs
maximum weight capacity or by towing anything behind
the vehicle. Avoid severe driving conditions, such as driving
up very steep hills or running into fixed objects, which can
cause the wheels to stop spinning while power is still being
supplied to the motors. If a thermal fuse continually trips,
contact your local Power Wheels
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the motor harness
connector, and that there are no loose wires around
the motors.
If your batteries are old or if you have not followed Battery
Care instructions, your batteries may be dead. If you are
unsure whether or not the batteries are dead, you can have
them tested at your local Power Wheels
service center.
The electrical switches can become corroded due to
exposure to water or moisture, or can jam due to loose dirt,
sand or gravel. Contact your local Power Wheels
authorized service center for diagnosis and repair.
Contact your local Power Wheels
for diagnosis and repair.
29
®
Consumer Affairs, toll-
Solution
®
thermal fuses before charging. For best
®
authorized service center.
®
authorized
®
authorized service center
authorized
®
Advertisement
Table of Contents
