Table of Contents
Advertisement
1:
Hold the transducer and bracket
assembly against the transom.
When the transducer and bracket
are properly aligned mark its
position on the hull.
2:
Drill the mounting holes for the
transducer bracket. For the one-
piece bracket use a #29 bit (for
the #10 screws). For the two-piece
bracket use a #20 bit (for the #12
screws).
Note:
Use the provided screws to secure the transducer assembly to the transom.
Water line
Clamp the transducer cable to the
transom near the transducer. This
will help keep the cable secure.
Be sure to use a below-waterline
marine grade sealant on all of the
transducer bracket screw holes.
When mounting a Skimmer
transducer to a boat with a veehull,
make sure the transducer center
line is aligned to the bottom of the
boat hull, as shown here.
If you drill a hole in the transom for
the transducer cable, make sure it
is located above the waterline. Seal
the hole with an above- or below-
waterline marine grade sealant.
20
Hide quick links:
Advertisement
Table of Contents
