Transducer Installation; Recommended Tools And Supplies - Lowrance HDS series Installation Manual

Transducer Installation

Recommended Tools and Supplies

Tools and Supplies (not included)
If you plan to route the transducer cable through the transom, you will need either a 1" drill
bit or a 5/8" drill bit depending on the size of the transducer cable connector. Each transom
mount requires a high quality, marine grade above- or below-waterline sealant/adhesive
compound. The following installations also call for these recommended tools and supplies.
One-piece Bracket Transom Installation
Tools:
two adjustable wrenches or socket wrench, drill, #29 (0.136") drill bit, screwdriver.
Supplies: none.
Two-piece Bracket Transom Installation
Tools:
two adjustable wrenches or socket wrench, drill, #20 (0.161") drill bit, screwdriver.
Supplies: four, 1" long, #12 stainless steel wood screws.
TMB-S Bracket Trolling Motor Installation
Tools:
two adjustable wrenches or socket wrench, screwdriver. Supplies: plastic cable ties.
Skimmer Transducer Shoot-through Hull Installation
Supplies:
alcohol wipes, 60 and 160 grit sandpaper, and marine grade above- or below-
waterline epoxy adhesive.
Pod Transducer Shoot-through Hull Installation
Supplies:
alcohol wipes, 60 and 160 grit sandpaper, and marine grade above- or below-
waterline epoxy adhesive.
14