Advertisement
INSTRUCTIONS FOR USE – M Series Pivot Arm
Pivot
1. To pivot the Arm (near the wall), simply push on the side of the Arm or mounted device.
2. To adjust the pivot tension at the Slide, use a ½" (or 13mm) socket driver to tighten or loosen the Pivot
Tension Bolt to obtain the desired tension.
Swivel
1) To rotate the device simply push or pull the corners of the device.
2) To adjust the swivel tension, use a ½" (or 13mm) socket driver to tighten or loosen the Swivel Tension Adjustment Bolt
located under the front end of the Arm.
Tilt
1. Grasp the top and bottom of the device and tilt it to the desired angle.
2. To adjust the overall tilt tension, evenly tighten or loosen the (2) #10-32 x 5/8" SHCS Tilt Tension Adjustment Screws
using the supplied 5/32 (4 mm) hex key.
Cable Management
1. An open cavity beneath the arm with flexible cable covers manage cables going to and from the front and rear of the
arm.
Pivot Arm
Swivel Tension Bolt
Pivot Tension Bolt
Flexible Cable Covers
DU-DR-0016-SC9000 Rev A 6/4/02 GCX Corp. Page 3 of 4
Advertisement
