Calling; Dialling With Number Keys; End Call; Set Volume - Siemens PEGASUS-DTC AX72 User Manual

Hide thumbs Also See for PEGASUS-DTC AX72:
Table of Contents

Advertisement

left page (10)
of AX72 Pegasus-DTC, FUG, en, A31008-H2860-A1-1-7619 (06.10.2005, 08:28)
10

Calling

Change phonecode
You define the phone code (4-8 digits)
when you call up a protected function for
the first time. It is then valid for all phone-
code protected functions. If the wrong
code is entered three times then the
phone will be locked. Contact Siemens
Customer Care for instructions on how to
unlock your pone.
Clear SIM card barring
If the PIN is entered incorrectly three
times, the SIM card is barred. Enter the
PUK (MASTER PIN), provided by your serv-
ice provider with the SIM card, according
to instructions. If the PUK (MASTER PIN)
has been lost, please contact your service
provider.
Preventing accidental activation
Even if PIN control is deactivated confir-
mation is required to switch on the phone.
This prevents the phone from being
switched on accidentally, e. g. when car-
ried in a pocket or whilst you are on an
aircraft.
Press and hold the On/Off/End key
and confirm with
switches on.
Calling

Dialling with number keys

The phone must be switched on (standby
mode). Dial number (always with area
code, if necessary with international dial-
ling code). To dial international dialling
code press and hold
played. Press
B
. The phone
§OK§
0
until a "+" is dis-
and select country.
§+List§
Short press
to clear the last digit, a
§Clear§
long press clears the entire phone
number. To dial press the Call key

End call

B
Press the End key
key even if the person on the other end of
the line has hung up first.

Set volume

E
Use navigation key
the volume during conversation. Set vol-
ume with navigation key
If a Car Kit is used, its volume setting will
not affect the usual setting on the phone.

Redial

To redial numbers that were dialled previ-
ously, press the Call Key
the required phone number from the list
G
A
with
, then press

If the number is busy

Press
for automatically dialling
§Auto dial§
the phone number ten times at increas-
ing time intervalls or press
for phone ringing when the busy number
is free. Press
and a beep reminds
§Prompt§
you to redial the dispayed phone number
after 15 minutes.

Accept call

The phone must be switched on (standby
mode). An incoming call will interrupt
any other use of the phone. Press
A
or
.
Please make sure you have accepted the call
before holding the phone to your ear. This will
avoid damage to your hearing from loud ring
tones!
A
.
briefly. Press this
to start adjusting
G
.
A
once, pick up
again.
L
(
)
§Call back§
§Answer§

Advertisement

Table of Contents
loading

Table of Contents