Table of Contents
Advertisement
9
Front Axle
• Fit a hubcap on the front axle and slide it into the center
of the front wheel.
10
Front Axle
• Slide a hex bushing onto the front axle. The ring side of
the hex bushing should face out.
• Press firmly to fit all but the ring on the end of the hex
bushing into the front wheel.
Assembly
Front Hubcap
• Fit a cap nut on the end of the front axle.
• Tap the cap nut with a hammer to secure it on the end of
• Pull on the wheel to make sure the cap nut is securely
• Repeat this procedure to assemble the other front wheel
Hex Bushing
• Set the vehicle body aside.
Ring Side
• Position the handlebar so that the side with the three
• Fit the neck against the bottom of the handlebar, with
• Insert a 1
• Fit a lock nut on the end of each screw.
12
11
the front axle.
fastened.
to the other front axle.
12
Circular
Indentation
Handlebar
Neck
Lock Nut
holes and circular indentation faces up.
the holes in the handlebar and neck aligned.
1
/
" screw down through each of the two outer
2
holes in the handlebar and then through the neck.
• Using pliers to steady the lock nuts, tighten each screw
with a Phillips screwdriver. Do not over-tighten.
Cap Nut
Holes
Advertisement
Table of Contents
