Table of Contents
Advertisement
F
1
Cover Plate
• Fit the cover plate over the opening in the front of the
vehicle body.
• Insert two
1
/
" screws (silver) through the cover plate and
2
into the vehicle body.
Mudflap
2
Rear of
Vehicle Body
• Tip up the back end of the vehicle.
• Using safety scissors, remove the mudflaps from the
plastic connector. Dispose of the plastic connector.
• Align the holes in a mudflap with the screwpegs under
one of the rear fenders. Make sure the textured side of
the mudflap faces toward the seat.
• Insert four
1
/
" screws (silver) through the mudflap and
2
into the screwpegs.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to assemble the other mudflap to
the other rear fender.
Assembly
Do Not Omit Any Steps
3
Vehicle
Body
Rear Wheel
• Position the vehicle body upside down. Make sure that
the tabs on the gearboxes rest against the rear axle
support bars so the gearboxes and motors do not
hang down.
• Slide two large washers onto one of the rear axles.
• Slide a rear wheel, driver side first, onto the rear axle.
• Fit the teeth on the gearbox into the notches in the driver.
4
Rear Fender
(Underside)
• Fit a hubcap on the rear axle and slide it into the center
of the rear wheel.
10
Driver
Rear Axle
Rear Axle
Gearbox
Support Bar
Rear Axle
Large
Washers
Teeth
Tabs
Hubcap
Advertisement
Table of Contents
