Linn AKURATE MUSIC SERVER Installation Manual page 5

AKURATE MUSIC SERVER
INSTALLATION MANUAL
13. Press '1'. Enter the IP address of the NAS.
14. Press 's' to save the data.
15. Press 'q' to quit.
16. The Akurate Music Server will reboot. This will take a few minutes.
During this time install the Linntek Setup and Control utility on the
PC, if you have not already done so.
Setup for control via Ethernet
17. Start the Linntek utility.
18. Right-click on the Linntek's title bar and choose 'Settings' from the
menus. Select 'Ethernet' and enter the IP address of the Akurate
Music Server. Select 'OK', close Linntek and restart it.
19. The Akurate Music Server can now be controlled via Linntek.
Setup for control via serial port
The Akurate Music Server is factory configured with Com 1 as the default
communication port, therefore if you have connected the PC to Com 1
you will be able to use Linntek to control the unit without making any
changes. However, if you wish to use Com 2 on the Akurate Music Server,
do the following:
Right-click on the Linntek's title bar and choose 'Settings' from the
menus. Select 'COM 2' and enter the IP address of the Akurate Music
Server. Select 'OK', close Linntek and restart it.
* If you wish to connect the Akurate Music Server to the installation PC
via serial port, use a suitable length of nine-way to nine-way null modem
cable or standard nine-way to nine-way cable with the following pin
configuration:
Connect plug 1 pin 5 to plug 2 pin 5
Connect plug 1 pin 2 to plug 2 pin 3
Connect plug 1 pin 3 to plug 2 pin 2
Connect plug 1 pin 7 to plug 2 pin 8
Connect plug 1 pin 8 to plug 2 pin 7
Connect plug 1 pin 4 to plug 2 pin 6
Connect plug 1 pin 6 to plug 2 pin 4
4
www.lin n.c o .u k