Linn AKURATE MUSIC SERVER Installation Manual page 3

AKURATE MUSIC SERVER
INSTALLATION MANUAL
Connecting - Back panel
1
1. Mains input
Connect to the mains supply using the mains lead provided
2. Com 1 & 2
For connection to a Linn Kivor Linnk*, PC or third-party control
device (see Getting Started guide)
3. Keyboard
For connection to a PS/2 keyboard during setup
4. VGA monitor output
For connection to a monitor during setup
5. Ethernet
For connection to an Ethernet network (port 1 only, port 2
is not used)
6. Com 3 (modem)
For connection to an external dial-up modem
2 3 4
1
1 2
2
2
5 6
8
L
3
R
7. Analogue out
Eight pairs of line outputs for connection to a Linn Knekt Intersekt*
or other pre-amplifier
* If you wish to use your Akurate Music Server in a Linn Knekt system,
the unit must be connected to a Linn Kivor Linnk.
The Akurate Music Server should be disconnected from the
mains supply before connecting or disconnecting any of the
plugs on the back panel. If this is not done you may generate
surges which could damage the Akurate Music Server or other
components in your multi-room or hi-fi system.
Important note:
If the Akurate Music Server has been powered off, it must be connected
to a live network on which the NAS is on and booted-up, before it is
powered back on, otherwise it will not boot-up correctly.
7
7 6 5 4 3 2 1
ANALOGUE AUDIO OUPUTS
www.lin n.c o .u k