Connecting; Back Panel; Power Button - Linn AKURATE MUSIC SERVER Owner's Manual

Connecting

Back panel

1 M M a a i i n n s s i i n n p p u u t t Connect to the mains supply using the mains lead provided
2 C C o o m m 1 1 & & 2 2 For connection to a Linn Kivor Linnk*, PC or third-party
control device (see Getting Started guide)
K K e e y y b b o o a a r r d d For Linn installer or Linn dealer use
3
4 V V G G A A m m o o n n i i t t o o r r o o u u t t p p u u t t For Linn installer or Linn dealer use
E E t t h h e e r r n n e e t t For connection to an Ethernet network (port 1 only, port 2 is
5
not used)
6 C C o o m m 3 3 ( ( m m o o d d e e m m ) ) For connection to an external dial-up modem
7 A A n n a a l l o o g g u u e e o o u u t t Eight pairs of line outputs for connection to a Linn Knekt
Intersekt* or other pre-amplifier
* If you wish to use your Akurate Music Server in a Linn Knekt system,
the unit must be connected to a Linn Kivor Linnk.

Power button

In the event that the unit does not power up when connected to the mains
supply, use a pin, straightened paper-clip or a similar implement to press
the power button, which is located behind the hole in the left-hand side of
the fascia.
5
1
1 2
2
8 7
L
3
R
I I m m p p o o r r t t a a n n t t n n o o t t e e : :
If the Akurate Music Server has been powered off, it must be
connected to a live network on which the storage device is on and
booted-up, before it is powered back on, otherwise it will not boot-
up correctly.
The Akurate Music Server should be disconnected from the
mains supply before connecting or disconnecting any of the
plugs on the back panel. If this is not done you may generate
surges which could damage the Akurate Music Server or other
components in your multi-room or hi-fi system.
Before disconnecting the Akurate Music Server from the mains supply,
it m m u u s s t t be put into standby.
T T o o p p u u t t t t h h e e A A k k u u r r a a t t e e M M u u s s i i c c S S e e r r v v e e r r i i n n t t o o s s t t a a n n d d b b y y ( ( u u s s i i n n g g t t h h e e L L i i n n n n t t e e k k
C C o o n n t t r r o o l l U U t t i i l l i i t t y y ) ) : :
• Right-click on the title bar.
• Select C C l l o o s s e e a a n n d d K K i i v v o o r r : : S S t t a a n n d d b b y y . .
• Wait for two minutes.
The unit can now be disconnected from the mains supply.
6 5 4 3 2 1
ANALOGUE AUDIO OUPUTS
AKURATE MUSIC SERVER 3