Table of Contents
Advertisement
N
IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions
Guide below. If you still experience a problem, please contact Power Wheels
toll-free at 1-800-348-0751 between 8 AM and 5 PM (EST) Monday through Friday. Or, contact
your local Power Wheels
the Authorized Service Center list beginning on page 23.
Problem
Vehicle does not run
Vehicle was running but
suddenly stopped
Problems and Solutions Guide
authorized service center. For the location nearest you, please refer to
®
Possible Cause
Undercharged battery
Charger is not working
Tripped thermal fuse in battery
Loose wire or loose connectors
Dead battery
Electrical switch damage
Motor damage
Loose wire or loose connectors
Charge the battery. A new battery should have been
charged for at least 18 hours before using the vehicle for
the first time. After first-time use, recharge the battery for at
least 14 hours after each use. Never charge the battery
longer than 30 hours.
Check all connectors. Make sure the battery connector is
tightly plugged into the charger connector, and that the
charger is plugged into the wall.
Make sure power flow to the wall outlet is "ON".
There is no sure way to tell if your charger is working unless
you have a volt meter. If you suspect there is a problem with
your charger, contact your local Power Wheels
service center. They can test your charger for you.
The built-in thermal fuse may "trip" and shut down operation
of the vehicle is the vehicle is overloaded or the driving
conditions too severe. The fuse will automatically reset itself
after approximately 25 seconds allowing the vehicle to
resume normal operation. To avoid repeated automatic shut
downs, do not overload the vehicle by exceeding the 65 lbs.
maximum weight capacity or by towing anything behind the
vehicle. Avoid severe driving conditions, such as driving up
very steep hills or running into fixed objects, which can
cause the wheels to stop spinning while power is still being
supplied to the motors. If the thermal fuse continually trips,
contact your local Power Wheels
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the motor harness
connector, and that there are no loose wires around
the motor.
If your battery is old or if you have not followed Battery
Care instructions, your battery may be dead. If you are
unsure whether or not the battery is dead, you can have
it tested at your local Power Wheels
service center.
The electrical switches can become corroded due to
exposure to water or moisture, or can jam due to loose dirt,
sand or gravel. Contact your local Power Wheels
authorized service center for diagnosis and repair.
Contact your local Power Wheels
for diagnosis and repair.
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the motor harness
connector, and that there are no loose wires around the
motor.
20
®
Consumer Affairs,
Solution
®
authorized
®
authorized service center.
®
authorized
®
®
authorized service center
Advertisement
Table of Contents
