Table of Contents
Advertisement
F
1
Tabs
• Position the dash cover as shown. Make sure the
three tabs are at the top.
• Fit the knob into the hole in the right side of the
dash cover.
• Fit the key into the hole to the left of the knob.
• Insert a #6 x
3
/
" screw into the back of the knob and into
8
the back of the key.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
2
Slots
• Insert the tabs on the top of the dash cover into the slots
in the dash.
• Lower the bottom of the dash cover.
• Insert two #6 x
1
/
" screws through the dash cover and
2
into the dash.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Assembly
Do Not Omit Any Steps
Key
Knob
Dash Cover
Dash
Tabs
Cover
3
Slot
• Insert the end of the microphone cord through the hole
in the right side of the dash.
• From the underside of the vehicle, bend the end of the
microphone cord so that it forms a "T" under the dash.
• Gently pull on the microphone cord to make sure it is
secure in the dash.
• Fit the tab on the back of the microphone into the slot in
the dash to secure the microphone.
4
Front Axle
Helpful Hint: You may want the help of another person to
complete assembly steps 4 through 7.
• Wipe the steering column with a paper towel to remove
any excess lubricant.
• Carefully lift the front end of the vehicle.
• Insert the straight end of the steering column under the
front axle, through the slot in the vehicle body and out
9
through the large hole in the center of the dash.
"T" End
Tab
Hole
"T" End
Steering Column
Bottom View
Microphone
Slot
Advertisement
Table of Contents
