Set Features Command (Ef H ) - Seagate Medalist Pro Family Product Manual

32 Medalist Pro 6450/6451 Product Manual, Rev. B
3.2.2 Set Features command (EF
The Set Features command (command code EF
and disable the multisegmented cache and Automatic Reallocation
features and to identify the transfer modes the drives use. The multiseg-
mented buffer consists of Read Look-ahead and write-immediate and
write-merging features. The table below lists the features the drives
support. The features that are set to default by the factory are indicated
in the Feature column.
To use the command:
1. Write the Feature value to the Features register.
2. Write the Set Features command to the command register.
Note. If the value in the Features register is not supported or is invalid,
the drives post an Aborted Command error.
At power-on or after a hard reset, the feature selections are restored to
the factory-default values.
The table below shows alterable features that the drives support. Values
that are preset at the factory are indicated as default in the feature
description.
Feature Value Feature
02 Enable write cache (default)
H
03 Set transfer mode
H
04 Enable Read Automatic Reallocation (default)
H
55 Disable read look-ahead cache
H
82 Disable write cache
H
84 Disable Read Automatic Reallocation
H
AA Enable read look-ahead cache (default)
H
)
H
) allows you to enable
H