Seagate HAWK 2LP Family Installation Manual page 8

6 Hawk 2LP (Wide) Installation Guide, Rev. A
Safety instructions
1. The disc drive(s) are to be installed in a customer
supplied enclosure where the surrounding air does
o
not exceed 50 C.
2. Four (4) 6-32 UNC-2A screws are required for
installation. Maximum screw length into side of
drive is 0.15 inches (3.81 mm). Maximum screw
length into bottom is 0.20 in. (5.08 mm). Maximum
screw tightening torque is 6.0 in-lb (.675 NM) with
minimum thread engagement of 0.12 in (3.05 mm).
3. The power requirements are shown in the Product
Information section.
4. The power supply must satisfy the safety require-
ments for SELV (Safety Extra Low Voltage) cir-
cuits.
5. Service is to be provided by trained Seagate ser-
vice personnel.
6. The incorporation of the disc drives listed in this
guide into a customer enclosure must meet the
appropriate safety requirements of the country in
which it is used (e.g. UL 1950, CAN/CSA-C22.2
No. 950-M89, DIN VDE 0805:1993 and EN60950:
1992 (IEC 950).
Note. Power must be off when connecting or discon-
necting.