Schumacher SE-2254 Owner's Manual page 6

(2) 10-32, thread cutting screws
(4) ¼-20, thread cutting screws
(4) Phillips head sheet metal screws
(2) wheels
(1) axle
(2) axle caps
(2) axle brackets
(1) handle
(1) foot
Assemble the Wheels and Axle: Hold the axle upright
on the floor or work surface. Then, using a hammer, tap
one of the axle caps onto the top end of the axle. Be
sure to tap the axle cap on straight. Slide both wheels
onto the axle with the recessed hubs facing out as
shown. Install the second axle cap.
Attach the Handle: If the charger came with a plastic grip,
slide that onto the handle until it is centered at the top. Turn the
charger right side up onto its foot and wheels. Align the handle
so the screw holes are aligned with the screw holes on the upper
back corners of the charger. Attach the handle using the four
Phillips head screws provided.
PARTS
Attach the Foot: Remove the charger
from the packing materials and place upside down
on a flat surface. Attach the foot and secure it
with the four ¼-20 thread cutting screws provided.
TOOLS NEEDED
3/8" wrench (for mounting foot)
5/16" wrench (for mounting wheels)
1/4" wrench (for mounting handle)
hammer
screwdriver (flat blade)
screwdriver (Phillips)
Mount the Axle to the Charger: Place
one end of each bracket into the slot on
the bottom of the charger. Place the axle
assembly under each bracket. Attach
the brackets using the two, 10-32 thread
cutting screws provided.
NOTE: Be careful not to drop the
brackets inside of the charger case.
6
• •